Part Description: 2005 Chevrolet Blazer Seal-Front Wheel Hub (O Ring) *Marked Print
More Info
Vehicle Fitment
2005 Chevrolet Blazer | Base, LS, LT, Trailblazer, Xtreme, ZR2 | 6 Cyl 4.3 L GAS
FAQ for Axle Shaft Seal Repair
Q: What is the recommended torque for the inner axle shaft seal cover?
A:
The recommended torque is 25 Nm (18 ft. lbs.).
By Bob
GM Specialist
28/10/2022
Q: How to install the Rear Axle Shaft Seal and/or Bearing?
A:
You need to install the axle shaft bearing into the axle tube, install the axle shaft seal, the axle shaft, the rear axle housing cover, and the tire and wheel assembly, and finally fill the rear axle.
By Bob
GM Specialist
28/10/2022
Q: What kind of special tools will be required when serving the Rear Axle Shaft Seal and/or Bearing?
Q: How to handle it when replacing the right-side seal and/or bearing?
A:
You need to remove the inner axle shaft and housing assembly, remove the inner axle shaft from the inner axle shaft housing, next install the J29369-1 to the backside of the bearing, and install the J23907 to the J29369-1, then remove the bearing and the seal by pulling on the J23907.
By Bob
GM Specialist
28/10/2022
FAQ for Other Repair Info
Q: When should you replace the universal joint?
A:
You should replace it when one or more of the Universal Joints are worn or damaged, or they have lost lubricant.
Q: What should be cared about when removing the axle shaft?
A:
When removing the Axle Shaft, do not rotate the shaft. Rotating the shaft will misalign the gears. Misaligning the gears will make the assembly difficult.
Q: How to remove the Lubricant-Front Drive Axle?
A:
You need to remove the front Differential carrier shield, remove the fill plug and the washer, remove the drain plug and the washer, then drain the fluid from the front axle differential.