Notes: Blazer; 2WD; 3.73 Ratio;Blazer; 4WD; 3.73 Ratio
Other Names: Axle Shaft
Item Dimensions: 28.1 x 6.2 x 6.3 inches
Item Weight: 13.60 Pounds
Fitment Type: Direct Replacement
Part Description: 2005 Chevrolet Blazer Rear Axle Drive Shaft
More Info
Vehicle Fitment
2005 Chevrolet Blazer | Base, LS, Xtreme, ZR2 | 6 Cyl 4.3 L GAS
1-30 of 38 Results
< Previous
12
Next >
FAQ for Axle Shaft Repair
Q: What is the recommended torque for the wheel drive shaft nut?
A:
The recommended torque is 140 Nm (103 ft. lbs.).
By Bob
GM Specialist
01/11/2022
Q: What is the recommended torque for the pinion shaft locking bolt?
A:
The recommended torque is 25 Nm (18 ft. lbs.).
By Bob
GM Specialist
01/11/2022
Q: What should be cared about when removing the axle shaft?
A:
When removing the axle shaft, do not rotate the shaft. Rotating the shaft will misalign the gears. Misaligning the gears will make the assembly difficult.
By Bob
GM Specialist
01/11/2022
Q: How to install the wheel drive shaft to the differential carrier properly?
A:
With both hands on the tripot housing, align the splines on the shaft with the differential carrier. Next, center the drive axle into the differential carrier seal. Then, firmly push the shaft straight into the differential carrier until the snap ring seats into place.
By Bob
GM Specialist
01/11/2022
FAQ for Other Repair Info
Q: When should you replace the universal joint?
A:
You should replace it when one or more of the Universal Joints are worn or damaged, or they have lost lubricant.
Q: How to remove the Lubricant-Front Drive Axle?
A:
You need to remove the front Differential carrier shield, remove the fill plug and the washer, remove the drain plug and the washer, then drain the fluid from the front axle differential.
Q: What kind of special tools will be required when serving the Rear Axle Shaft Seal and/or Bearing?