2010 Chevrolet Express 3500 Door Contact Switch

The procedure is to install the sliding side door lower track to the vehicle, the bolts that retain the sliding side door lower track to the vehicle, the sliding side door lower roller bracket, and the sliding side Door Check assembly.

You need to paint the service hinges body color, remove the door that requires hinge replacement and interior trim at the pillar, cut the production body side Door Hinge, tape around the periphery of the body side hinge to mark the hinge location, place the service backing plate on the production hinge surface and mark the 3-hole pattern, drill pilot holes with a 3 mm (1/8 in) drill bit through the production hinge and body pillar, protect the interior of the vehicle and the adjacent door interior from potential metal grindings, lightly sand the body side hinge surface to locate the 3 production welds, look for witness mark, drill out the remainder of the production hinge without drilling through the body side hinge pillar, cut the hinge weld nuggets off, grind the pillar hinge mating surface flush, and then drill 13 mm (33/64 in) holes through the pillar.

You can install the lock cylinder rod to the front Door Lock Cylinder, the front door lock cylinder into the front door lock cylinder hole, and the front door lock cylinder retainer to the front door lock cylinder, and connect the front door lock cylinder rod to the front door lock and then install the front door water deflector and the front door panel.