Part Description: 2009 Chevrolet Express 2500 Camshaft
More Info
Vehicle Fitment
2009 Chevrolet Express 2500 | Base, LS, LT | 8 Cyl 6.6 L DIESEL
FAQ for Camshaft Repair
Q: What is the recommended torque for the CMP actuator magnet bolts?
A:
The recommended torque is 12 Nm (106 lb in).
By Bob
GM Specialist
03/02/2022
Q: What kind of special tools will be required for the removal of the Camshaft?
A:
EN 46330 Timing Belt Tensioner Retaining Pin.
By Bob
GM Specialist
28/01/2022
Q: What should you notice during the installation of the Camshaft Position Actuator Magnet?
A:
You need to know that the gasket surface should be free of oil or other foreign material during assembly.
By Bob
GM Specialist
26/01/2022
Q: What should you pay attention to when removing or installing the camshaft?
A:
You should know that all camshaft journals are the same diameter, so care must be used in removing or installing the camshaft to avoid damage to the camshaft bearings.
By Bob
GM Specialist
25/01/2022
FAQ for Other Repair Info
Q: Can you turn the crankshaft assembly off after the timing chain has been removed?
A:
No, do not turn the crankshaft assembly after the Timing Chain has been removed, to prevent damage to the piston assemblies or the valves.
Q: Why shouldn't you use belt dressing on the drive belt?
A:
Since belt dressing causes the breakdown of the composition of the Drive Belt. Failure to follow this recommendation will damage the drive belt.
Q: Can you reuse the CMP solenoid valve?
A:
No, DO NOT use the CMP solenoid valve again. Install a NEW valve during assembly.