Part Description: 2006 GMC Yukon Evaporator, Auxiliary A/C
More Info
Vehicle Fitment
2006 GMC Yukon | Denali, SL, SLE, SLT | 8 Cyl 4.8 L GAS, 8 Cyl 5.3 L FLEX, 8 Cyl 5.3 L GAS, 8 Cyl 6.0 L GAS
FAQ for A/C Evaporator Core Repair
Q: What is the recommended torque for the screws to the HVAC module assembly?
A:
The recommended torque is 2 Nm (18 lb in).
By Bob
GM Specialist
28/10/2022
Q: What is the removal procedure for the evaporator core (Visteon)?
A:
You need to remove the HVAC module, disconnect the electrical connector from the recirculation actuator, and remove the screws, the evaporator cover, the evaporator cowl gasket, and the evaporator core.
By Bob
GM Specialist
28/10/2022
Q: What is the removal procedure for the evaporator core (Delphi)?
A:
You need to remove the HVAC module, remove the heat stakes from the HVAC module, the screws from the HVAC module assembly, and the evaporator cowl gasket from the evaporator, separate the upper HVAC module assembly from the lower HVAC module assembly and remove the evaporator core.
By Bob
GM Specialist
28/10/2022
Q: How to install the evaporator core (Visteon)?
A:
You need to install the evaporator core, the evaporator cowl gasket, the evaporator cover, and the screws, connect the electrical connector to the recirculation actuator, and install the HVAC module assembly.
By Bob
GM Specialist
28/10/2022
FAQ for Other Repair Info
Q: What is the removal procedure for the ambient air temperature sensor?
A:
You need to remove the Park/Turn Signal, disconnect the electrical connector from the ambient Air Temperature Sensor, and remove the ambient air temperature sensor.
Q: What should we do when the vehicle is operated in ambient temperature conditions of 23 °C (-10°F) or below?
A:
You should replace the Blower Motor control module if the vehicle experienced a blower motor control module failure in extremely cold ambient temperature conditions.
Q: What is the removal procedure for the blower motor resistor in the auxiliary?
A:
You need to remove the right rear quarter trim panel, disconnect the electrical connector from the Blower Motor Resistor, and remove the retaining screws from the blower motor resistor and the blower motor resistor.