2004 GMC Yukon | Denali, SL, SLE, SLT | 8 Cyl 4.8 L GAS, 8 Cyl 5.3 L FLEX, 8 Cyl 5.3 L GAS, 8 Cyl 6.0 L GAS
FAQ for Door Lock Switch Repair
Q: What is the installation procedure for the accessory switch?
A:
You can connect the electrical connectors, install the accessory switch assembly into the IP and install the IP trim bezel.
By Bob
GM Specialist
01/11/2022
Q: What is the first step for installing the passenger door lock and side window switch?
A:
The first step is to install the door module into the switch panel bezel until it snaps into place.
By Bob
GM Specialist
01/11/2022
Q: What tool can you use to release the retaining clips on both sides of the door module?
A:
You can use a wide plastic flat-bladed tool.
By Bob
GM Specialist
01/11/2022
Q: What is the recommended torque when installing the screw that retains the switch panel bezel to the front door panel?
A:
You can tighten the screw to 2 N.m (18 lb in).
By Bob
GM Specialist
01/11/2022
Q: How do you replace the accessory switch?
A:
You can remove the IP trim bezel, grasp the accessory switch assembly and pull outwards to remove the button assembly, disconnect the electrical connectors and remove the switches and the button assembly.
By Bob
GM Specialist
01/11/2022
Q: What is the removal procedure for the passenger door lock and side window switch?
A:
The procedure is to remove the following: the front door trim panel, the screw that retains the switch panel bezel to the front door trim panel, the switch panel bezel from the door panel, and the door module from the switch panel bezel.
By Bob
GM Specialist
01/11/2022
See more FAQs (1)
FAQ for Other Repair Info
Q: What should you replace if the hinge pins or bushings are damaged?
Q: What is the removal procedure for the front door lock actuator?
A:
The procedure is to remove the following: the door trim panel, the water deflector, the rubber plug, the bolts retaining the Door Lock Actuator to the door, the door lock actuator, and the control rods as an assembly and the control rods.
Q: How do you replace the rear door bumper?
A:
You can remove the bumper bolts and remove the bumper assembly.