2004 GMC Yukon | Denali, SL, SLE, SLT | 8 Cyl 4.8 L GAS, 8 Cyl 5.3 L FLEX, 8 Cyl 5.3 L GAS, 8 Cyl 6.0 L GAS
FAQ for Door Check Repair
Q: How do you replace the rear door bumper?
A:
You can remove the bumper bolts and remove the bumper assembly.
By Bob
GM Specialist
01/11/2022
Q: What is the recommended torque when installing the check strap nuts?
A:
You can tighten the nuts to 9 N.m (80 lb in).
By Bob
GM Specialist
01/11/2022
Q: What is the removal procedure for the door check link?
A:
The procedure is to remove the following: the door trim panel, the water deflector, the body-side check strap bolt, the check strap plug, and the door-side check strap nuts.
By Bob
GM Specialist
01/11/2022
Q: What is the installation procedure for the rear door bumper?
A:
The procedure is to install the bumper assembly and install the bumper bolts.
By Bob
GM Specialist
01/11/2022
FAQ for Other Repair Info
Q: What should you replace if the hinge pins or bushings are damaged?
Q: What is the removal procedure for the front door lock actuator?
A:
The procedure is to remove the following: the door trim panel, the water deflector, the rubber plug, the bolts retaining the Door Lock Actuator to the door, the door lock actuator, and the control rods as an assembly and the control rods.
Q: What is the recommended torque when installing the upper bolt?