Other Names: Fuel Gauge Sending Unit, Level Sensor
Item Dimensions: 8.3 x 6.1 x 6.2 inches
Item Weight: 0.70 Pounds
Fitment Type: Direct Replacement
Replaces: 25340157
Part Description: 2004 Chevrolet Silverado 1500 Fuel Tank Meter/Pump SENSOR KIT
More Info
Vehicle Fitment
2004 Chevrolet Silverado 1500 | Base, Hybrid, LS, LT, SS, WT, Z71 | 6 Cyl 4.3 L GAS, 8 Cyl 4.8 L GAS, 8 Cyl 5.3 L ELECTRIC/GAS, 8 Cyl 5.3 L FLEX, 8 Cyl 5.3 L GAS, 8 Cyl 6.0 L GAS
FAQ for Fuel Level Sensor Repair
Q: What is the proper way to install the fuel lever sensor?
A:
The proper way is to install the fuel level sensor, the fuel level sensor retaining clip, the fuel level sensor electrical connector retaining clip, and the fuel sender.
By Bob
GM Specialist
01/11/2022
Q: What is the removal procedure for the fuel lever sensor?
A:
The procedure is to remove the fuel sender, the fuel level sensor electrical connector retaining clip, and the fuel level sensor.
By Bob
GM Specialist
01/11/2022
Q: What is the description of the fuel level sensor?
A:
The description is that the fuel level sensor consists of a float, a wire float arm, and a ceramic resistor card. The position of the float arm indicates the fuel level. The fuel level sensor contains a variable resistor that changes resistance in correspondence with the position of the float arm.
By Bob
GM Specialist
01/11/2022
FAQ for Other Repair Info
Q: What is the function of the bulletin?
A:
This bulletin is being issued to inform dealers that there are two different types of Fuel Caps used on all 2004 full-size pick-ups and utilities with gasoline engines.
Q: What is the description of the fuel injector?
A:
The description is that the Multec 2 Fuel Injector assembly is a solenoid device controlled by the control module that meters pressurized fuel to a single engine cylinder. The control module energizes the high-impedance, 12 ohms, injector solenoid to open a normally closed ball valve.
Q: What is the procedure for fuel system cleaning?
A:
The procedure is to remove the sending unit, inspect the fuel strainer and the fuel pump inlet for dirt and debris, flush the Fuel Tank with hot water, pour the water out of the fuel sender assembly opening, and then install the sending unit.