Q: What is the installation procedure for the sunroof motor?
A:
You need to install the sunroof motor and the 2 screws, connect the wire harness to the sunroof motor, install the headliner, and inspect the operation of the sunroof.
By Bob
GM Specialist
01/11/2022
Q: What is the procedure to synchronize the sunroof?
A:
You need to turn ON the ignition with the engine OFF, operate the sunroof glass until it reaches the full vent position using the close/tilt-up portion of the sunroof switch, and verify that the system operates normally.
By Bob
GM Specialist
01/11/2022
Q: What is the removal procedure for the sunroof motor/actuator?
A:
You need to remove the headliner, disconnect the wire harness from the sunroof motor, remove the 2 screws retaining the motor, and pull the motor from the unit.
By Bob
GM Specialist
01/11/2022
FAQ for Other Repair Info
Q: What is the removal procedure for the starter shield?
A:
You need to remove the Starter motor, the starter heat shield, the starter heat shield bolts, and the nut, and remove the starter heat shield.
Q: What is the removal procedure for the seat switch bezel?
A:
You need to remove the screws retaining the Power Seat Switch bezel, disconnect the electrical connectors, and remove the lumbar support switch and the power seat adjuster switch assembly.
Q: What is the removal procedure for the heated seat switch in the rear?
A:
You need to remove the center console end panel, disconnect the electrical connector, and remove the Seat Heater Switch retaining screws and the switch from the vehicle.