Q: What is the installation procedure for the license lamp (with step bumper)?
A:
You need to install the bulb and the lens to the lamp assembly and inspect the operation.
By Bob
GM Specialist
01/11/2022
Q: What is the removal procedure for the license lamp (with step bumper)?
A:
You need to ensure the headlamp switch is in the OFF position, and remove the lens from the lamp assembly and the bulb.
By Bob
GM Specialist
01/11/2022
FAQ for Other Repair Info
Q: What is the removal procedure for the starter shield?
A:
You need to remove the Starter motor, the starter heat shield, the starter heat shield bolts, and the nut, and remove the starter heat shield.
Q: What is the removal procedure for the lumbar switch?
A:
You need to remove the Power Seat Switch bezel containing the lumbar switch from the seat, the lumbar switch screws from the power seat switch bezel, and the lumbar switch.
Q: What is the removal procedure for the heated seat switch in the front?
A:
You need to remove the front door trim panel, disconnect the electrical connector, release the retaining clips for the front Seat Heater Switch assembly, and remove the front seat heater switch assembly.