Q: What is the removal procedure for lamp switch assembly of the front fog lamp and cargo lamp?
A:
You need to remove the instrument cluster bezel, remove the fog lamp switch and cargo switch from the housing, disconnect the electrical connector(s) from the fog lamp switch, and remove the fog lamp and cargo lamp switch from the housing.
By Bob
GM Specialist
01/11/2022
Q: What is the installation procedure for lamp switch assembly of the front fog lamp and cargo lamp?
A:
You need to connect the electrical connector(s) to the fog lamp and cargo lamp switch, install the fog lamp switch into the housing, and the IP trim bezel to the instrument panel.
By Bob
GM Specialist
01/11/2022
Q: What is the installation procedure for the rear fog lamp switch?
A:
You need to install the fog lamp switch into the accessory switch housing, connect the electrical connectors, and install the accessory switch housing and the instrument panel bezel.
By Bob
GM Specialist
01/11/2022
Q: What is the removal procedure for the rear fog lamp switch?
A:
You need to remove the instrument panel bezel, pull out the accessory switch housing, disconnect the electrical connectors, and remove the fog lamp switch from the accessory switch housing.
By Bob
GM Specialist
01/11/2022
FAQ for Other Repair Info
Q: What is the removal procedure for the starter shield?
A:
You need to remove the Starter motor, the starter heat shield, the starter heat shield bolts, and the nut, and remove the starter heat shield.
Q: What is the removal procedure for the seat switch bezel?
A:
You need to remove the screws retaining the Power Seat Switch bezel, disconnect the electrical connectors, and remove the lumbar support switch and the power seat adjuster switch assembly.
Q: What is the removal procedure for the heated seat switch in the front?
A:
You need to remove the front door trim panel, disconnect the electrical connector, release the retaining clips for the front Seat Heater Switch assembly, and remove the front seat heater switch assembly.