2000 Cadillac Escalade Intake Manifold

You need to remove the vacuum brake booster hose, if equipped, and disconnect the accelerator control and cruise control cables (if equipped). Remove the accelerator control cable bracket and set it aside, the PCV tube at the intake manifold, the engine wiring harness bracket from the manifold, the EVAP canister purge solenoid valve, the studs holding the upper intake manifold to the lower intake manifold, and the lower intake manifold.

You need to install the power steering bracket onto the stud, the nut onto the stud finger tight, the three bolts finger tight, and the two nuts to the back of the power steering pump and the power steering pump. Then connect the electrical connector to the power steering pump, the fuel pipes to the rear of the intake manifold, and the wiring bracket to the rear of the right cylinder head.

You need to remove the power steering pump, the nut, then the bolts, and then two nuts from the back of the power steering pump and slide the power steering bracket forward, with the power steering pump still attached.

You need to connect the SCPI injector harness connector, the EVAP canister purge solenoid valve, the ignition coil, the Ignition control module (ICM), the generator, the idle air control (IAC) motor, the throttle position (TP) sensor, the oxygen (02) sensor, the exhaust gas recirculation (EGR) valve, the engine coolant temperature (ECT) sensor, and the engine oil pressure sensor.