Part Description: 2011 Cadillac Escalade Composite Assembly
More Info
Vehicle Fitment
2011 Cadillac Escalade | Base, Hybrid, Hybrid Platinum, Luxury, Platinum, Premium | 8 Cyl 6.0 L ELECTRIC/FLEX, 8 Cyl 6.0 L ELECTRIC/GAS, 8 Cyl 6.2 L FLEX
FAQ for Headlight Repair
Q: Can Polycarbonate lenses be washed with car wash soap?
A:
Yes, the lens can be washed with car wash soap but you must make sure it's not highly concentrated in certain chemicals which may degrade the life of the headlight.
By Omar
GM Specialist
06/10/2021
Q: How do you replace the connector?
A:
You will need to cut the wires around 45 mm from the connector and splice in the new pigtail connector and install a new bulb.
By Bob
GM Specialist
06/10/2021
Q: If the lens gets damaged, can the lens be bought separately?
A:
No, avoid damage to the lens as the lens is only sold with the whole headlight assembly.
By Bob
GM Specialist
06/10/2021
Q: How do you replace the headlamp bulb?
A:
Remove the headlamp from the vehicle and remove the bulb. Carefully inspect the bulb and connector. If the connector is discolored you will need to replace the connector, if it is not discolored you can simply replace the bulb.
By Omar
GM Specialist
06/10/2021
FAQ for Other Repair Info
Q: What causes a battery clamp bolt to break?
A:
An over-tightened nut may cause the battery clamp bolt to break.
Q: How do you repair an airbag that's not flush?
A:
Start by disabling the SIR system, locking tab will be bent upwards so using a plastic trim stick gently move the panel up to expose the locking tab. Straighten the locking tab, press down on the airbag panel to seat in the correct position, and Enable the SIR system.
Q: How do you connect an aftermarket trailer brake controller?
A:
Locate Connector, locate the trailer brake control circuits, pull the trailering wire harness down, and match the vehicle harness label circuit functions to the trailer brake controller functions, break the tape on the red/black and remove the lid from the electrical center, and Place terminal on the larger of 2 studs at the front of the electrical center.