2010 GMC Canyon Window Motor

You need to remove the front door trim panel, the front door water deflector, the front door water deflector, and the front door window. Then you need to disconnect the electrical connector from the Window Regulator motor if equipped with A31, and loosen the bolts retaining the window regulator to the inner panel at the keyhole slot locations. After that, you need to remove the remaining fasteners retaining the window regulator to the inner panel. Finally, you need to remove the window regulator from the door.

You need to remove the front door trim panel, remove the front door water deflector, and raise the front door window. Then you need to remove the front door window weatherstrip from the window run channel and remove the bolt retaining the bottom of the window run channel to the door inner panel. After that, you need to slide the upper window run channel tab out of the front door window frame. Finally, you need to remove the window run channel from the front door.

You need to install the switch module to the switch plate and connect the electrical connectors to the switch module. Finally, you need to install the switch plate assembly to the door trim panel with the 2 screws.