2010 GMC Canyon Valve Cover

The recommended torque is 10 Nm (89 lb in).

You need to install a new camshaft cover seal into the camshaft cover groove and install new ignition coil seals into the camshaft cover grooves, and you need to place the camshaft cover onto the cylinder head. Then you need to install the camshaft cover bolts. Then you need to position the ground wire to the camshaft cover, after that, you need to install the camshaft cover ground wire bolt to the cover. After that, you need to install the fuel injector, the HO2S, and the ECT sensor to the camshaft cover, and you need to install the ignition oils. Finally, you need to install the intake manifold.

You need to remove the intake manifold and the ignition coils, and you need to remove the fuel injector, the heated oxygen sensor, and the engine coolant temperature (ECT) sensor. Then you need to remove the camshaft cover ground wire bolt and remove the ground wire from the cover. After that, you need to remove the camshaft cover bolts, remove the camshaft cover, and remove the seals from the camshaft cover. Finally, you need to clean and inspect the cylinder head sealing surface.