Material: Green Rubber O-Rings, Black Aluminum Gasket
Style: O-Ring & Gasket Kit
UPC: 096361268241
Part Description: 2010 GMC Canyon A C System O Ring And Gasket Kit
More Info
Vehicle Fitment
2010 GMC Canyon | All Trims | All Engines
$13.27
FAQ for A/C System Seal Kit Repair
Q: How to install the Air Conditioning O-Ring Seal?
A:
You need to inspect the new O-ring seal for any signs of cracks, cuts, or damage, and you need to remove the cap or tape from the A/C refrigerant components. Then you need to carefully clean the sealing surfaces of the A/C refrigerant components, and lightly coat the new O-ring seal with mineral base 525 viscosity refrigerant oil. After that, you need to carefully slide the new O-ring seal onto the A/C refrigerant component, and ensure that the O-ring seal must be fully seated. Finally, you need to assemble the A/C components.
By Bob
GM Specialist
28/10/2022
Q: How to remove the Air Conditioning System Seal?
A:
You need to remove the seal washer from the A/C refrigerant component and inspect the seal washer for signs of damage to help determine the root cause of the failure. Then you need to inspect the A/C refrigerant components for damage or burrs and discard the sealing washer.
By Bob
GM Specialist
28/10/2022
Q: How to install the Air Conditioning System Seal?
A:
You need to inspect the new seal washer for any signs of cracks, cuts, or damage, and remove the cap or tape from the A/C refrigerant components. Then you need to clean the sealing surfaces of the A/C refrigerant components, and carefully install the new seal washer onto the A/C refrigerant component. Finally, you need to assemble the remaining A/C refrigerant components. Refer to the appropriate repair procedure.
By Bob
GM Specialist
28/10/2022
Q: How to remove the Air Conditioning O-Ring Seal?
A:
You need to disassemble the A/C refrigerant components and remove the O-ring seal from the A/C refrigerant component. Then you need to inspect the O-ring seal for signs of damage to help determine the root cause of the failure. After that, you need to inspect the A/C refrigerant components for damage or burrs. Finally, you need to cap or tape the A/C refrigerant components and discard the O-ring seal.
By Bob
GM Specialist
28/10/2022
FAQ for Other Repair Info
Q: How to remove the Outside Temperature Display Sensor?
A:
You need to remove the air inlet grille, disconnect the electrical connector to the ambient Air Temperature Sensor, and release the tabs retaining the sensor to the radiator support bracket. Finally, you need to remove the sensor from the radiator support bracket.
Q: How to remove the Blower Motor?
A:
You need to remove the right hinge pillar trim panel. Then you need to remove the Blower Motor mounting screws and the blower motor cooling tube. After that, you need to disconnect the blower motor electrical connector. Finally, you can remove the Blower Motor.
Q: How to remove the Heater Core?
A:
You need to remove the HVAC module assembly, the Heater Core pipes clamp screw, the heater core pipes clamp, the heater core clamp screws and the heater core clamp sequentially. Then you can remove the heater core from the HVAC module.