Notes: w/Wheel; Original blower motor cover will not be used w/replacement motor
Cage Wheel Included: w/ Wheel
Connector Gender: Female
Connector qty: 1
Flanged End: Yes
Material: Plastic
Motor Diameter: 3.250
Mount Type: OE Mount
New or Reman: New
Number of Terminals: 2
O.E. Replacement: Yes
Printed Foot Note: Original blower motor cover will not be used with replacement motor
Rotation: CW
Shaft Diameter: 0.3125
Shaft Length: 1.375
Style: Flanged
Terminal Type: 2 Lead Wires w/ Connector
UPC: 096361757448
Vented: Vented
Voltage: 12
Wheel Dia. IN: 5.750
Wheel Height IN: 3.000
Part Description: 2010 GMC Canyon Hvac Blower Motor With Wheel
More Info
Vehicle Fitment
2010 GMC Canyon | All Trims | All Engines
$46.39
FAQ for Blower Motor Repair
Q: How to remove the Blower Motor?
A:
You need to remove the right hinge pillar trim panel. Then you need to remove the blower motor mounting screws and the blower motor cooling tube. After that, you need to disconnect the blower motor electrical connector. Finally, you can remove the Blower Motor.
By Bob
GM Specialist
01/11/2022
Q: How to install the Blower Motor?
A:
You need to install the blower motor and connect the blower motor electrical connector. Then you need to install the blower motor cooling tube. After that, you need to install the blower motor mounting screws. Finally, you need to install the right hinge pillar trim panel.
By Bob
GM Specialist
01/11/2022
Q: What is the recommended torque for the blower motor mounting screws?
A:
The recommended torque is 2 Nm (18 lb in).
By Bob
GM Specialist
01/11/2022
FAQ for Other Repair Info
Q: How to remove the Outside Temperature Display Sensor?
A:
You need to remove the air inlet grille, disconnect the electrical connector to the ambient Air Temperature Sensor, and release the tabs retaining the sensor to the radiator support bracket. Finally, you need to remove the sensor from the radiator support bracket.
Q: How to remove the Heater Core?
A:
You need to remove the HVAC module assembly, the Heater Core pipes clamp screw, the heater core pipes clamp, the heater core clamp screws and the heater core clamp sequentially. Then you can remove the heater core from the HVAC module.
Q: How to remove the Heater Outlet Pipe?
A:
You need to drain the cooling system and reposition the Heater Hose inlet clamp from the heater pipe outlet. Then you need to remove the heater hose inlet from the heater pipe outlet and loosen the heater pipe outlet. Finally, you can remove the heater pipe outlet.