Part Description: 2010 Chevrolet Traverse Wheelhouse Liner
More Info
Vehicle Fitment
2010 Chevrolet Traverse | LS, LT, LTZ | 6 Cyl 3.6 L GAS
FAQ for Fender Splash Shield Repair
Q: How many screws does the front wheelhouse liner have?
A:
It has 10 screws.
By Bob
GM Specialist
01/11/2022
Q: What is the recommended torque for the rear wheelhouse liner screws?
A:
The recommended torque is 2.5 N.m (22 lb in).
By Bob
GM Specialist
01/11/2022
Q: What is the preliminary procedure for servicing the front wheelhouse rear liner?
A:
The procedure is to remove the tire/wheel assembly.
By Bob
GM Specialist
01/11/2022
Q: What is the recommended torque for front wheelhouse liner screws?
A:
The recommended torque is 2.5 N.m (22 lb in).
By Bob
GM Specialist
01/11/2022
Q: How many rear screws does the front wheelhouse panel have?
A:
It has 4 screws.
By Bob
GM Specialist
01/11/2022
Q: What is the preliminary procedure for servicing the engine splash shield?
A:
The procedure is to remove the tire and wheel assembly.
By Bob
GM Specialist
01/11/2022
Q: How many plastic retainers does the engine splash shield attach?
A:
It attaches 3 retainers.
By Bob
GM Specialist
01/11/2022
Q: What is the recommended torque for front wheelhouse panel rear screws?
A:
The recommended torque is 1.5 N.m (13 lb in).
By Bob
GM Specialist
01/11/2022
Q: How many screws does the rear wheelhouse liner attach?
A:
It attaches 4 screws.
By Bob
GM Specialist
01/11/2022
Q: What is the preliminary procedure for servicing the rear wheelhouse panel liner?
A:
The procedure is to remove the tire and wheel assembly.
By Bob
GM Specialist
01/11/2022
See more FAQs (11)
FAQ for Other Repair Info
Q: What is the preliminary procedure for servicing the spare wheel hoist?
A:
The procedure is to remove the tire and wheel from the Spare Tire Hoist and raise and support the vehicle.
Q: How to service the windshield washer pump assembly?
A:
You shall, using two flat-bladed tools, at the pump gasket, pry upwards until the Washer Pump is dislodged from the washer container, and discard the windshield washer pump grommet.
Q: How to remove the rear side door window regulator?
A:
You shall remove the door trim panel, the water deflector, the energy absorber retainers, the energy absorber, the regulator/motor from the door, the Window Regulator motor, and the regulator.