Part Description: 2010 Chevrolet Traverse Mount Brace Bolt
More Info
Vehicle Fitment
2010 Chevrolet Traverse | High Country, L, LS, LT, LTZ, Premier, RS | 6 Cyl 3.6 L GAS
$4.73MSRP: $7.50
You Save: $2.77 (37%)
FAQ for Camber and Alignment Kit Repair
Q: What should be noticed while adjusting the rear camber?
A:
You shall make sure that the camber settings have not changed after torquing the adjuster nut to specifications.
By Bob
GM Specialist
01/11/2022
Q: How to adjust the rear camber?
A:
You shall loosen the adjuster cam nut, rotate the adjuster bolt, adjust the cam to specifications, check the toe alignment and adjust if required, and test drive the vehicle.
By Bob
GM Specialist
01/11/2022
Q: What is the recommended torque for the adjuster nut?
A:
The recommended torque is 140 N.m (103 lb-ft).
By Bob
GM Specialist
01/11/2022
Q: How to measure the front and rear alignment angles?
A:
You shall install the alignment equipment according to the manufacturer's instructions, jounce the front and the rear bumpers 3 times before checking the wheel alignment, measure the alignment angles, record the readings, and adjust alignment angles to vehicle specification, if necessary.
By Bob
GM Specialist
01/11/2022
Q: How to adjust the steering wheel angle and/or front toe?
A:
You shall remove the power steering gear seal small clamps, verify that the steering wheel is centered and the wheels are in the straight-ahead position, loosen the left and right tie rod jam nuts, and rotate the inner tie rods to obtain the proper toe angle of 0 degrees, tighten the tie rod end jam nuts, and install the power steering gear seal small clamps.
By Bob
GM Specialist
01/11/2022
Q: How to adjust the rear toe?
A:
You shall loosen the adjuster nut, rotate the adjuster bolt, adjust the cam to specifications, hold the adjuster bolt, tighten the adjuster nut, check the toe alignment and adjust if required, and test drive the vehicle.
By Bob
GM Specialist
01/11/2022
Q: How to adjust the front camber?
A:
You shall remove the tire and wheel, and the strut lower bolt in order to inspect for an oblong strut lower hole, install the strut bolts, but do not fully tighten them, adjust the camber and tighten the strut nuts, and install the tire and wheel.
By Bob
GM Specialist
01/11/2022
See more FAQs (2)
FAQ for Other Repair Info
Q: What kind of tools will be required while servicing the parking brake rear cable-right side?
Q: What is the preliminary procedure for servicing the steering knuckle?
A:
The procedure is to remove the wheel bearing/hub assembly and disconnect the outer tie rod from the Steering Knuckle, and the lower ball joint from the steering knuckle.
Q: How to remove the intermediate steering shaft?
A:
You shall turn the steering wheel to the straight forward position and lock it in place, hoist the vehicle and raise it, disengage the intermediate Steering Shaft boot from the steering gear and the intermediate steering shaft upper seal, and remove the left side instrument panel insulator panel and the intermediate steering shaft.