2010 Chevrolet Cobalt Spark Plug

Start with installing the Blower Motor into the motor cup, then install the blower motor by attaching the nuts, and attach the service ring to the motor cup using the screws included with the kit. Then install the blower motor and service ring into the HVAC module with screws included in the kit, then install the motor cover and retaining screws. Lastly, connect the blower motor's electrical connector.

Start with placing the HVAC case in its correct spot, and then install the lower HVAC screws and tighten them to 1.8 Nm (15 lb in). Close the passenger compartment filter door and inspect the foam Heater Core seal. If damaged, replace. Attach the heater core to the HVAC module and install the heater core cover. Replace the drain tube seal and the front of the dash seal, place the HVAC module in the vehicle and fill the cooling system.

Start by removing the clutch pedal retainer from the front of the clutch pedal assembly, and pull the clutch upward to disengage the Clutch Master Cylinder pushrod from the pedal. Remove UBEC, to avoid oil spills place a shop towel under the clutch master cylinder. Disconnect the clutch hose and line from the master cylinder. Rotate the clutch master cylinder one 1/4 turn clockwise to remove.