FAQ for Driveshaft Repair
Q: How do you install the propeller shaft slip-yoke boot?
A:
You can install the boot to the propeller shaft and slip joint, and install the propeller shaft.
By OmarGM Specialist
20/10/2021 Q: How do you install the 2 piece propeller shaft?
A:
You can install the new propeller shaft coupler, the propeller shaft, and the center support bearing bolts.
By BobGM Specialist
20/10/2021 Q: What are the Centre bearing and rubber couplings used for?
A:
The bearing and coupling are used to support and connect the propeller shaft as well as decrease any noise or vibration.
By BobGM Specialist
20/10/2021 Q: What causes the vehicle to have ping or snap noises?
A:
Ping or snapping noises may be due to the rubber coupling being damaged, as well as the propeller shaft being loose.
By OmarGM Specialist
19/10/2021 Q: What causes the 2010 Chevrolet Camaro to have knock or clunk noises?
A:
The knock or clunk noises may be due to the universal joint or the rear coupling being damaged, or the side gear being oversized.
By BobGM Specialist
19/10/2021 Q: What causes the Camaro to make scraping noises?
A:
For the Camaro to have scraping noises the exhaust or other parts are touching the propeller shaft, or the flange is rubbing.
By BobGM Specialist
19/10/2021 Q: What is the cause of the universal joint noise?
A:
The cause is one or more joints being damaged or having lost lubricant.
By BobGM Specialist
18/10/2021 Q: What is the proper way to remove the 2 piece propeller shaft?
A:
The proper way is to remove the heat shield, and the propeller shaft, and discard the shaft coupler.
By BobGM Specialist
17/10/2021 Q: What makes the vehicle shudder at a low speed of acceleration?
A:
The bearing rubber cushion or universal joint being damaged may cause these noises.
By BobGM Specialist
16/10/2021 Q: What is the removal procedure for the propeller shaft slip-yoke boot?
A:
The procedure is to remove the propeller shaft as well as the boot.
By OmarGM Specialist
16/10/2021 See more FAQs (5)