Part Description: 2010 Chevrolet Avalanche Ring-Steering Gear Stub Shaft Seal Retainer
More Info
Vehicle Fitment
2010 Chevrolet Avalanche | Black Diamond LS, Black Diamond LT, Black Diamond LTZ, LS, LT, LTZ | 8 Cyl 5.3 L FLEX, 8 Cyl 5.3 L GAS, 8 Cyl 6.0 L GAS
FAQ for Rack And Pinion Seal Repair
Q: How do you install the drive pinion housing and seal?
A:
You can install the pinion gear bearing retainer, the propeller shaft, and the rear axle shafts.
By Bob
GM Specialist
02/11/2022
Q: How do you remove the drive pinion flange?
A:
You can remove the tire/wheel, the rear brake rotors, the propeller shaft, and the washer.
By Bob
GM Specialist
02/11/2022
Q: What is the proper way to remove the drive pinion housing and seal?
A:
The proper way is to remove the axle shafts, the propeller shaft, and the collapsible spacer.
By Bob
GM Specialist
02/11/2022
Q: What is the proper way to install the drive pinion flange?
A:
The proper way is to install the washer, the nut, the axle shafts, and the rear brake rotors.
By Bob
GM Specialist
02/11/2022
FAQ for Other Repair Info
Q: What is the proper way to remove the steering shaft coupling?
A:
The proper way is to remove the engine shield, the Steering Shaft coupling bolt, and the steering shaft coupling.
Q: What is the removal procedure for the power vacuum brake booster?
A:
The procedure is to release the brake pedal, disconnect the electrical connector, remove the power brake vacuum sensor, and remove the power vacuum Brake Booster.
Q: How many pins are in the brake master cylinder reservoir?