FAQ for Brake Master Cylinder Repair
Q: How many pins are in the brake master cylinder reservoir?
A:
There are 2 pins in the brake master cylinder.
By BobGM Specialist
01/11/2022 Q: How many fittings are in the brake pipe?
A:
2fittings attach to the brake pipe.
By BobGM Specialist
01/11/2022 Q: What is the recommended bolt torque for the brake pushrod retainer nut?
A:
The recommended bolt torque Is 10 Nm (89 lb. in).
By BobGM Specialist
01/11/2022 Q: How many retainers attach to the ABS module splash shield?
A:
2retainers attach the splash shield.
By BobGM Specialist
01/11/2022 Q: Will the vehicle need to be lifted?
A:
Yes, you will need to lift and support the vehicle.
By BobGM Specialist
01/11/2022 Q: How many seals are in the master cylinder reservoir?
A:
2seals are in the master cylinder reservoir.
By BobGM Specialist
01/11/2022 Q: What should be done before filling the brake master cylinder reservoir?
A:
Visually inspect the brake fluid level through the brake master cylinder reservoir. If the brake fluid level is at or below the half-full point during routine fluid checks, the brake system should be inspected for wear and possible brake fluid leaks.
By BobGM Specialist
01/11/2022 Q: What should be done before removing the brake fluid from the master cylinder?
A:
Turn the ignition off, without pausing at the accessory, and remove the ignition key. Wait for approximately 1 to 3 minutes until the brake modulator and HPA pressure relief are complete.
By BobGM Specialist
01/11/2022 Q: What is the recommended bolt torque for the pedal bracket nuts?
A:
The recommended bolt torque is 25 Nm (18 lb. ft.).
By BobGM Specialist
01/11/2022 Q: How do I engage the pressure relief?
A:
Turn the ignition off, without pausing at the accessory, and without applying the brake pedal. Remove the ignition key. Wait for approximately 1 to 3 minutes until the brake modulator and HPA pressure relief are complete.
By BobGM Specialist
01/11/2022 See more FAQs (19)