Notes: w/Gas Shock Kit; Fully Assembled Ready To Install
UPC: 817778026404
Part Description: 2010 Buick Enclave Front and Rear Suspension Strut and Coil Spring Assembly Set
More Info
Vehicle Fitment
2010 Buick Enclave | All Trims | 6 Cyl 3.6L
2010 Buick Enclave | All Trims | All Engines
FAQ for Shock Absorber Repair
Q: What is the recommended torque for the mounting nut?
A:
The recommended torque is 45 N.m (33 lb-ft).
By Bob
GM Specialist
01/11/2022
Q: What should be done before servicing the Strut Assembly?
A:
Remove the air inlet grille.
By Bob
GM Specialist
01/11/2022
Q: What should be noticed when servicing the Shock Absorber?
A:
Gas-charged shock absorbers contain high-pressure gas. Do not remove the snap ring from inside the top of the tube. If the snap ring is removed, the contents of the shock absorber will come out with extreme force which may result in personal injury.
By Bob
GM Specialist
01/11/2022
Q: What should be noticed when servicing the Suspension Shock/Strut?
A:
Use the proper eye protection when drilling to prevent metal chips from causing physical injury.
By Bob
GM Specialist
01/11/2022
Q: What should be done before servicing the Shock Absorber?
A:
Raise and support the vehicle. Remove the rear tire and wheel.
By Bob
GM Specialist
01/11/2022
FAQ for Other Repair Info
Q: What special tool will I need when servicing the Parking Brake Front Cable?
Q: What is the installation procedure for the Intermediate Steering Shaft Boot?
A:
Install the intermediate Steering Shaft boot, the intermediate steering shaft, and the left front tire/wheel assembly.
Q: What is the removal procedure for the Power Brake Booster Auxiliary Pump?
A:
Turn the ignition switch to the OFF position. Apply and release the brake pedal several times. Remove the fuel injector sight shield. Release the quick connect. Position the vacuum Brake Booster hose assembly aside. Disconnect the power brake booster auxiliary pump electrical connector. Release the power brake booster auxiliary pump electrical connector. Remove the power brake booster auxiliary pump bolts and the pump. Remove the power brake booster auxiliary pump insulators and sleeves. Remove the power brake booster auxiliary pump bracket bolts and bracket.