Part Description: 2009 GMC Sierra 1500 Knock Sensor
More Info
Vehicle Fitment
2009 GMC Sierra 1500 | WT | 6 Cyl 4.3 L GAS
$14.17MSRP: $26.71
You Save: $12.54 (47%)
FAQ for Knock Sensor Repair
Q: How do you install the knock sensor 1?
A:
You can position the knock sensor to the engine block and install the knock sensor bolt and connect the engine wiring harness electrical connector to the knock sensor.
By Bob
GM Specialist
01/11/2022
Q: How do you install the knock sensor 2?
A:
You can position the knock sensor to the engine block, install the knock sensor bolt and connect the engine wiring harness electrical connector to the knock sensor.
By Bob
GM Specialist
01/11/2022
Q: What is the removal procedure for knock sensor 1?
A:
The procedure is to lift and support the vehicle, disconnect the engine wiring harness electrical connector and remove the knock sensor bolt and knock sensor.
By Bob
GM Specialist
01/11/2022
Q: What is the removal procedure for the knock sensor 2?
A:
The procedure is to lift the vehicle, disconnect the engine wiring harness electrical connector and remove the knock sensor bolt and knock sensor.
By Bob
GM Specialist
01/11/2022
FAQ for Other Repair Info
Q: How do you remove the spark plug wire from the ignition coil?
A:
You can twist the spark plug wire boot a 1/2 turn and pull only on the boot to remove the wire from the Ignition Coil.
Q: What is the removal procedure for the ignition lock cylinder?
A:
The procedure is to disable the SIR system, remove the steering column shroud, install the key, install a wrench into the hole on top of the Ignition Lock Cylinder case and slide the ignition lock cylinder out of the ignition lock cylinder case.
Q: What should you do when diagnosing or replacing the control module?
A:
You should inspect the control module connector gaskets when diagnosing or replacing the control module.