2009 Chevrolet Equinox Camber and Alignment Kit

First, loosen the suspension adjustment link-to-frame fastener and rotate the suspension adjustment nut in the direction necessary to correct the toe angle. Next, snug the suspension adjustment link-to-frame fastener, hold the nut, and tighten the link-to-frame fastener bolt to 164 Nm. Repeat the procedure for the other rear wheel.

First, position and lock the steering wheel with the vehicle with the wheels in a straightforward position. Next, loosen both inner tie rod jam nuts and the inner tie rod seal to boot the surface. After that, use a wrench on the tie rod flats and tighten the inner tie rod jam nuts to 60 Nm.

Remove the wheel/tire assemblies, and remove the strut to knuckle nuts and bolts. Install the new strut to knuckle nuts and bolts. Make sure to tighten the knuckle nuts and bolts to 180 Nm and install the wheel/tire assemblies.

You need to install the alignment equipment according to the manufacturer's instructions, next jounce the front and the rear bumpers 3 times before checking the wheel alignment, then measure the alignment angles and record the readings, and adjust alignment angles to vehicle specification, if necessary.

First, loosen the upper control arm-to-frame fasteners to allow movement. Next, hold the nut and tighten the upper control arm-to-frame bolt to 164 Nm.