Part Description: 2009 Cadillac XLR Module Asm-Electronic Suspension Control
More Info
Vehicle Fitment
2009 Cadillac XLR | Platinum, V | 8 Cyl 4.4 L GAS, 8 Cyl 4.6 L GAS
FAQ for Suspension Control Module Repair
Q: What should you remove before you replace the electronic suspension control module?
A:
You should remove the wheelhouse liner from the vehicle.
By Bob
GM Specialist
01/11/2022
FAQ for Other Repair Info
Q: What is the proper way to install the parking brake rear cable?
A:
The proper way is to install the rear Parking Brake Cable, connect the park brake cable, and install the muffler.
Q: What is the steering column electronic lock installation procedure?
A:
First, install the electronic lock module onto the Steering Column and feed the electronic column lock lead into the wire harness assembly. Next, install the new wire harness straps, the turn signal cancel cam, and the windshield wiper wash/switch assembly. After that install the multifunction switch assembly, and the steering column into the vehicle and enable the SIR system.
Q: What is the steering knuckle installation procedure?
A:
Install the Steering Knuckle to the upper control arm and the lower control arm. Next, remove the jack stand, install the steering linkage outer tie rod ball stud to the steering knuckle, the stabilizer shaft link to the lower control arm and tighten to 72 Nm. Connect the wheel speed sensor electrical connector, and install the brake rotor and the caliper. Install the tire/wheel assembly and check the front wheel toe.