Contact Us Live Chat or 1-888-220-8330
Search Bar
Search by Part Number or Keywords
  • My Garage
  • My Account
  • Cart
  • Body & Mirrors
  • Chassis & Brakes
  • Engine & Drivetrain
  • Electrical & Lighting
Help Center
< Back ×
  • Body & Mirrors
  • Chassis & Brakes
  • Engine & Drivetrain
  • Electrical & Lighting
Login/Register My Account Track Order Help Center Contact Us
Replacement and OEM Parts for 2008 GMC Yukon Differential Mount

2008 GMC Yukon Differential Mount

My Vehicle Change Vehicle
2008 GMC Yukon
Change Vehicle
Vehicle Options
Select Trim
Select Engine
We need more information about your vehicle to make a correct determination of fitment
< Back to View All
Driveline, Axles & 4WD
  • Department
  • Brands
  • Prices

1 Product found

2 Q&A for Differential Mount Repair
Show Item:
  • 30
  • 60
  • 90
Sort by:
Recommended
Filter
Sort
View by

FAQ for Differential Mount Repair

Q: How do you remove the upper differential carrier assembly bushing?
A:
You should install the J 36616-2, the J 33791-1, the thrust bearing, the J 21474-18, and the forcing screw as shown, and remove the upper differential carrier assembly bushing by holding the forcing screw and slowly tightening the J 21474-18.
By Bob
GM Specialist
01/11/2022
Q: What are the required tools for the differential carrier assembly bushing replacement?
A:
The required tools are the J 33791 Carrier Bushing Remover/Installer and the J 36616 Axle Mount Bushing Remover/Installer.
By Bob
GM Specialist
01/11/2022

FAQ for Other Repair Info

Q: What should you do when you remove the axle shaft?
A:
You should not rotate the shaft, because rotating the shaft will misalign the gears, which will make the installation of the Axle Shaft difficult.
Q: How do you remove the Front Axle Lubricant?
A:
You can raise the vehicle, remove the front Differential carrier shield, clean the area around the front axle fill plug and the drain plug, remove the fill plug, remove the drain plug and drain the fluid from the front differential carrier assembly.
Q: What is the assembly procedure for the Universal Joint Replacement?
A:
You should remove the bearing cups, assemble 1 bearing cup part way into 1 side of the yoke, turn the yoke ear toward the bottom, assemble the cross into the yoke, assemble the opposite bearing cup part way into the yoke ear, press the opposite bearing cup into the yoke ear, press the bearing cup into the yoke, assemble the bearing retainer and lubricate the snap ring with a slight amount of chassis grease.