2008 Cadillac XLR Floor Pan

You should install the accelerator pedal stop, the driver-side footrest, the side sill trim plate, the door manual release actuator, and the seat.

You should remove the seat, the door manual release actuator, the door sill trim plate, the accelerator pedal stop bracket, the driver footrest, and the carpet.

You should start at the lock pillar, lift the sill plate, unsnap the sill plate from the hinge pillar, and slide the sill plate out from under the hinge pillar upper trim, and on the driver side out from around the hood release handle and the foot rest.

The recommended torque is 10 N.m (89 lb in).

You should position the front of the sill plate under the hinge pillar upper trim with the rear of the sill plate tilted up, lower the rear of the sill plate inserting the front of the sill plate behind the hood release handle and the footrest (driver side), push forward on the sill plate aligning the sill plate retainers with the slots in the door opening finish trim panel, and snap the sill trim plate into the hinge pillar first and then into the door opening finish trim panel.