2008 Cadillac SRX Seat Cushion Pad

You should remove the front bucket seat, the seat cushion from the seat, the push-in retainer from the trim covers, the trim covers, the seat back cover and pad, and the front seat belt assembly, note the electrical wiring routing during disassembly in order to ensure proper electrical wiring routing during reassembly, disconnect and remove the remaining electrical connectors are attached to the seat back frame, remove the bolt retaining the seat back frame to the riser and the bolts retaining the seat back frame to the recliner and lift up on the seat back frame in order to disengage the seat back from the recliner.

The recommended torque is 35 Nm (26 lb-ft).

The recommended torque is 2 Nm (18 lb in).

You should remove the seat from the vehicle, the left seat cushion, the pivot trim cover screws, and the outer pivot covers, disconnect the J-channel retainers and remove the seat back retaining bolts and the seat back from the seat adjuster.

You should install the seat bezel kit using the steps below, open the rear lift gate and press the unlock button on the key FOB three times to enable the power folding seat. Then, you should use the power seat button to position the third-row power seat halfway up through the seating cycle, then remove the existing seat back latch bezels if still attached (separate the heat stakes on the bottom side of the bezel) and install the key lock side of the latch bezel through the top of the seat back panel with the two plastic pins in the down position, the bottom piece of the latch bezel with the tapered edge toward the top edge of the rear seat back panel as shown in the illustration above and the two metal retainers, P/N 9428633, over the ends of the two plastic pins.