You should release the brake pipe, section the brake pipe, measure the length of the pipe, cut the brake pipe squarely, remove the sectioned brake pipe, select the appropriate size of brake pipe and tube nuts, strip the nylon coating, chamfer the inside and outside diameter of the pipe, install the tube nuts, loosen the die clamping screw of the J 45405, select the corresponding die set, install the die halves, place the flat face of an unused die, insert the prepared end of the pipe, remove the unused die, rotate the hydraulic fluid control valve clockwise, the body of the J 45405 and the hydraulic fluid control valve counterclockwise, the hydraulic fluid control valve clockwise, the body of the J 45405 and the hydraulic fluid control valve counterclockwise, loosen the die clamping screw, remove the dies and pipe, inspect the brake pipe flare, shape and install the new pipe, bleed the hydraulic brake system and inspect the brake pipe flares.
By BobGM Specialist
01/11/2022