< Back ×
My Vehicle Change Vehicle
2008 Cadillac DTS
< Back to View All
Fuel Systems
- Department
- Prices
OEM (Genuine) 2008 Cadillac DTS Fuel Gauge Sending Unit
PartNumber: 19179766
Product Specifications- Notes: Dts
- Other Names: Fuel Gauge Sending Unit, Level Sensor
- Item Dimensions: 11.3 x 3.9 x 3.8 inches
- Item Weight: 0.30 Pounds
- Fitment Type: Direct Replacement
- Replaces: 19177202
- Part Description: 2008 Cadillac DTS Fuel Gauge Sending Unit
Vehicle Fitment- 2008 Cadillac DTS | Base, Livery, Luxury, Platinum, Premium | 8 Cyl 4.6 L GAS
$80.74 MSRP:$152.38You Save: $71.64 (48%)
FAQ for Fuel Level Sensor Repair
Q: How to install the fuel level sensor?
A:
You may need to slide the fuel level sensor up onto the bucket, lift up on the locking tab, continue sliding the sensor up until it engages the tab, connect the fuel level sensor electrical connector under the module cover, then install the fuel pump module.
By Bob
GM Specialist
01/11/2022Q: What's the recommended torque for the fuel sender access hole cover bolts?
A:
The recommended torque is 2 N.m (18 lb in).
By Bob
GM Specialist
01/11/2022Q: What should be noticed when removing the module from the fuel tank?
A:
You will need to be aware that the module reservoir bucket is full of fuel. The module must be tipped slightly during removal to avoid bending the fuel level sensor float arm.
By Bob
GM Specialist
01/11/2022Q: What should be noticed when installing the fuel sender assembly?
A:
You will need to always replace the fuel sender seal when installing the fuel sender assembly. You can replace the lock ring if necessary. You should not apply any type of lubrication in the seal groove.
By Bob
GM Specialist
01/11/2022Q: How to install the Fuel Level Sensor Wiring Harness?
A:
You may need to install the fuel level sensor wiring harness, connect the fuel level sensor wiring harness electrical connectors to the pressure sensor and module, and install the fuel tank.
By Bob
GM Specialist
01/11/2022Q: How to remove the Fuel Level Sensor Wiring Harness?
A:
You will need to remove the fuel tank, disconnect the fuel level sensor wiring harness electrical connectors from the pressure sensor and module, then remove the fuel level sensor wiring harness.
By Bob
GM Specialist
01/11/2022Q: How to remove the fuel level sensor?
A:
You will need to remove the fuel pump module, release the fuel level sensor electrical connector clip, disconnect the fuel level sensor electrical connector from under the fuel module cover, then release the locking tab and slide the fuel level sensor down off of the bucket.
By Bob
GM Specialist
01/11/2022See more FAQs (2)