Part Description: 2007 Chevrolet Cobalt Cam Asm-Mode Control
More Info
Vehicle Fitment
2007 Chevrolet Cobalt | Base, LS, LT, LTZ, Sport, SS | 4 Cyl 2.0 L GAS, 4 Cyl 2.2 L GAS, 4 Cyl 2.4 L GAS
FAQ for Hvac Heater Blend Door Actuator Repair
Q: What is the proper way to install the recirculation actuator?
A:
The proper way is to install the recirculation actuator, the recirculation actuator screw, the recirculation electrical connector, the I/P retainer, and the fuse labeled HVAC CTRL (BATT).
By Bob
GM Specialist
01/11/2022
Q: What is the removal procedure for the recirculation actuator?
A:
The procedure is to remove the fuse labeled HVAC CTRL (BATT), the instrument panel (I/P) retainer, and the recirculation actuator.
By Bob
GM Specialist
01/11/2022
Q: What is the removal procedure for the mode actuator?
A:
The procedure is to remove the air temperature actuator, disconnect the mode actuator electrical connector, and then remove the mode actuator assembly.
By Bob
GM Specialist
01/11/2022
Q: What is the proper way to install the mode actuator?
A:
The proper way is to install the mode actuator assembly, the mode actuator electrical connector, and the air temperature actuator, start the engine, and let run for one minute.
By Bob
GM Specialist
01/11/2022
Q: What is the proper way to install the air temperature actuator?
A:
The proper way is to install the air temperature actuator, the air temperature actuator screws, the air temperature actuator electrical connector, the steering column filler panel, and the fuse labeled HVAC CTRL (BATT).
By Bob
GM Specialist
01/11/2022
Q: What is the removal procedure for the air temperature actuator?
A:
The procedure is to remove the fuse labeled HVAC CTRL (BATT), the steering column filler panel, the air temperature actuator screws, and the air temperature actuator.
By Bob
GM Specialist
01/11/2022
See more FAQs (1)
FAQ for Other Repair Info
Q: What is the removal procedure for the heater assembly?
A:
The procedure is to remove the HVAC module, the Heater Core cover, the heater core, the lower HVAC case heat stakes, and the lower HVAC case.
Q: What is the proper way to install the blower motor?
A:
The proper way is to install the Blower Motor, the blower motor nuts, the blower motor, the service ring, and the lower blower motor cover, and then connect the blower motor electrical connector.
Q: What is the proper way to install the blower motor resistor?
A:
The proper way is to snap the Blower Motor Resistor into the HVAC module, and then connect the blower motor electrical connector.