< Back ×
My Vehicle Change Vehicle
2007 Cadillac STS
< Back to View All
Steering Systems
- Department
- Prices
OEM (Genuine) 2007 Cadillac STS Sensor
PartNumber: 15231656
Product Specifications- Notes: Strg Whl Position; Sts, Sts-V; Steering Wheel Position
- Other Names: Position Sensor, Sensor
- Item Dimensions: 5.3 x 4.2 x 4.1 inches
- Item Weight: 0.40 Pounds
- Fitment Type: Direct Replacement
- Replaces: 26069756, 88965535
- Part Description: 2007 Cadillac STS Sensor
Vehicle Fitment- 2007 Cadillac STS | Base, Platinum, V | 6 Cyl 3.6 L GAS, 8 Cyl 4.4 L GAS, 8 Cyl 4.6 L GAS
$112.60 MSRP:$186.40You Save: $73.80 (40%)
OEM (Genuine) 2007 Cadillac STS Sensor Asm, Steering Column Telescope Position
PartNumber: 89060602
Product Specifications- Notes: Telescopic Position; Sts, Sts-V; Telescope Position
- Other Names: Position Sensor, Sensor
- Item Dimensions: 5.7 x 4.0 x 3.7 inches
- Item Weight: 0.70 Pounds
- Fitment Type: Direct Replacement
- Part Description: 2007 Cadillac STS Sensor Asm, Steering Column Telescope Position
Vehicle Fitment- 2007 Cadillac STS | Base, Platinum, V | 6 Cyl 3.6 L GAS, 8 Cyl 4.4 L GAS, 8 Cyl 4.6 L GAS
OEM (Genuine) 2007 Cadillac STS Sensor Asm, Steering Column Tilt Wheel Position
PartNumber: 89060599
Product Specifications- Notes: Tilt Position; Sts, Sts-V; Tilt Position
- Other Names: Position Sensor, Sensor
- Item Dimensions: 5.1 x 4.2 x 4.1 inches
- Item Weight: 0.70 Pounds
- Fitment Type: Direct Replacement
- Part Description: 2007 Cadillac STS Sensor Asm, Steering Column Tilt Wheel Position
Vehicle Fitment- 2007 Cadillac STS | Base, Platinum, V | 6 Cyl 3.6 L GAS, 8 Cyl 4.4 L GAS, 8 Cyl 4.6 L GAS
FAQ for Steering Angle Sensor Repair
Q: What do you need to remove from the steering shaft?
A:
You need to remove the boot seal, the steering shaft seal, the sensor retainer, and the sensor locator.
By Bob
GM Specialist
01/11/2022Q: What should you ensure before removing the sensor?
A:
You need to identify the type of steering wheel position sensor from the illustrations shown BEFORE removing the sensor from the steering column.
By Bob
GM Specialist
01/11/2022Q: What do you need to do if reusing the existing sensor?
A:
If reusing the existing sensor, you must make an alignment mark on the rotor flange cuff before removing the sensor. Failure to do so will cause misalignment when installing the sensor. A new sensor will be required if misaligned.
By Bob
GM Specialist
01/11/2022