Part Description: 2007 Cadillac CTS Manifold Asm, Intake (Service)
More Info
Vehicle Fitment
2007 Cadillac CTS | V | 8 Cyl 6.0 L GAS
FAQ for Intake Manifold Repair
Q: What is the proper way to install the Rear Upper Intake Manifold Cover?
A:
You should install the cover, the wiper motor module assembly, the driver-side air inlet panel, the passenger-side air inlet screen panel, the engine cover/sight shield, and the oil fill cap.
By Bob
GM Specialist
01/11/2022
Q: What is the removal procedure for the Rear Upper Intake Manifold Cover?
A:
The procedure is to remove the oil fill cap, the engine cover/sight shield, the hood seal, the passenger side air inlet screen panel, the driver's side air inlet screen, the wiper motor module assembly, and the cover.
By Bob
GM Specialist
01/11/2022
Q: What should be noticed while dealing with the fuel pipe?
A:
DO NOT kink or damage the fuel pipe.
By Bob
GM Specialist
01/11/2022
Q: What should be noticed while dealing with the intake manifold bolts?
A:
Do not remove the upper to lower intake manifold bolts.
By Bob
GM Specialist
01/11/2022
Q: What should be noticed before installing the lower intake manifold gasket?
A:
Inspect and replace the lower intake manifold gasket only if the gasket is worn or damaged.
By Bob
GM Specialist
01/11/2022
Q: What should be noticed before installing the connecting the throttle body electrical connector?
A:
The wiring harness connector must be installed straight onto the component connector and firmly seated. Visually inspect the connector to ensure that the connector latches are engaged and locked.
By Bob
GM Specialist
01/11/2022
Q: What should be noticed before installing the upper intake manifold bolts?
A:
Tighten the intake manifold bolts in a circular pattern starting at the center (long bolts) and moving outward.
By Bob
GM Specialist
01/11/2022
See more FAQs (2)
FAQ for Other Repair Info
Q: What should be noticed while servicing the Throttle Body?
A:
Do not subject a Throttle Body assembly that contains the throttle position sensor, idle air control valve, and sealed throttle shaft bearings to an immersion cleaner or a strong solvent.
Q: What is the proper way to install the Air Cleaner Element?
A:
Install the air cleaner element and the air cleaner intake duct.
Q: What is the proper way to remove the Mass Airflow Sensor?
A:
Remove the air cleaner intake duct and the MAF sensor.