Notes: Front AC, 1st Design; OE recommended replacement part.
Color: Black
Length: 87.00
Tube Outside Diameter: 09.600
UPC: 042511098015
Part Description: 2006 GMC Yukon A/C Orifice Tube
More Info
Vehicle Fitment
2006 GMC Yukon | All Trims | 8 Cyl 4.8L
2006 GMC Yukon | All Trims | 8 Cyl 5.3L
2006 GMC Yukon | Denali | 8 Cyl 6.0L
Show More
FAQ for A/C Orifice Tube Repair
Q: How to install the expansion (orifice) tube?
A:
You need to uncap or unplug the evaporator tube, install the new O-ring seal and the short screen end of the new orifice, connect the evaporator tube, evacuate and recharge the system, and leak test the fittings of the repaired component.
By Bob
GM Specialist
28/10/2022
Q: What is the removal procedure for the expansion (orifice) tube?
A:
You need to recover the refrigerant, loosen the nut from the evaporator tube fitting, remove the orifice tube from the evaporator tube, and cap or plug the open line.
By Bob
GM Specialist
28/10/2022
FAQ for Other Repair Info
Q: What is the removal procedure for the air temperature sensor in the lower right?
A:
You need to remove the I/P lower closeout panel, the right floor duct, and the center console, disconnect the electrical connector from the lower right Air Temperature Sensor, and remove the lower right air temperature sensor.
Q: What should we do when the vehicle is operated in ambient temperature conditions of 23 °C (-10°F) or below?
A:
You should replace the Blower Motor control module if the vehicle experienced a blower motor control module failure in extremely cold ambient temperature conditions.
Q: What is the removal procedure for the blower motor resistor in the auxiliary?
A:
You need to remove the right rear quarter trim panel, disconnect the electrical connector from the Blower Motor Resistor, and remove the retaining screws from the blower motor resistor and the blower motor resistor.