Notes: Grade: Actual OE; Terminal Quantity: 6; Availability: Available to Order; Bore Dia: 72.0; Gasket Or Seal Included: Yes; Idle Air Control Motor Included: No; Throttle Body Type: Electric; Throttle Position Sensor Included: Yes
Actuation Type: Electric
Bore Diameter: 72.0 mm
Gasket or Seal Included: Yes
Hardware Included: No
Idle Air Control Motor Included: No
Manufacturer: Hitachi
New or Remanufactured: New
OE Part Number: 12609500
Qty Needed Per Unit: 1
Terminal Connector Type: Blade
Terminal Gender: Male
Terminal Quantity: 6
Throttle Body Type: Electric
Throttle Position Sensor Included: Yes
UPC: 840151060207
Part Description: 2006 Chevrolet Impala Fuel Injection Throttle Body
Part Description: 2006 Chevrolet Impala Throttle Body
More Info
Vehicle Fitment
2006 Chevrolet Impala | SS | 8 Cyl 5.3 L GAS
FAQ for Throttle Body Repair
Q: What should be done before inserting fingers into the throttle bore?
A:
Turn OFF the ignition before inserting your fingers into the throttle bore. Unexpected movement of the throttle blade could cause personal injury.
By Bob
GM Specialist
02/11/2022
Q: What is the recommended torque for the throttle body bolts?
A:
The recommended torque is 10 N.m (89 lb in).
By Bob
GM Specialist
02/11/2022
Q: What should be done before servicing the Throttle Body Assembly?
A:
Remove the engine sight shield.
By Bob
GM Specialist
02/11/2022
FAQ for Other Repair Info
Q: What should be done before making warranty repairs?
A:
If an aftermarket reusable Air Filter is used, technicians should inspect the MAF sensor element and the air induction hose for contamination of oil before making warranty repairs.
Q: What is the installation procedure for the Manifold Absolute Pressure (Map) Sensor?
A:
Lubricate the MAP Sensor grommet with clean engine oil, if required. Install the MAP sensor grommet, if required. Install the MAP sensor. Connect the MAP sensor electrical connector. Install the engine sight shield.
Q: What should be noticed when servicing the Intake Manifold?
A:
The Intake Manifold, throttle body, fuel rail, and injectors may be removed as an assembly. If not servicing the individual components, remove the manifold as a complete assembly.