2005 Chevrolet Colorado | Base, LS, LT, Sport, Sport LS, WT, Z71, Z71 LS, Z85, Z85 LS | 4 Cyl 2.8 L GAS, 4 Cyl 2.9 L GAS, 5 Cyl 3.5 L GAS, 5 Cyl 3.7 L GAS, 8 Cyl 5.3 L GAS
Part Description: 2005 Chevrolet Colorado Rear Leaf Spring Shackle
More Info
Vehicle Fitment
2005 Chevrolet Colorado | All Trims | All Engines
$20.09
FAQ for Leaf Spring Shackle Repair
Q: How do you install the spring shackle?
A:
You should install the shackle assembly to the spring, the shackle nut and bolt to the spring, and the shackle nut and bolt to the frame, and remove the rear axle support.
By Bob
GM Specialist
01/11/2022
Q: How do you remove the spring shackle?
A:
You should remove the shackle nut and the bolt from the frame, the shackle nut and the bolt from the spring, and the shackle assembly from the vehicle.
By Bob
GM Specialist
01/11/2022
FAQ for Other Repair Info
Q: How do you remove the park brake cable-right rear?
A:
You should remove the adjusting nut for the parking brake, the front park brake cable from the equalizer, the right park brake cable from the equalizer, the right park brake cable from the retainer on the left frame rail, short wheelbase, the retaining bolt for the right park brake cable, the right park brake cable from the retainer on the left frame rail, long wheelbase, the retaining bolt for the park brake cable, the park brake cable from the cross member, the right park brake cable retaining bolts from the right rear frame rail, the retaining nut at the right rear spring bracket, the park brake cable from the retaining bracket, the rear brakes shoes, the park brake cable, and the Parking Brake Cable from the backing plate.
Q: How do you install the power steering hose assembly?
A:
You should install the Power Steering Hose assembly to the vehicle, install the power steering hose assembly to the power steering gear bolt and the power steering hose assembly clip retaining bolts, and remove the drain pan from under the vehicle.
Q: How do you remove the steering knuckle-4WD?
A:
You should remove the tire and wheel, the wheel drive shaft nut, the brake caliper bracket, the upper control arm retaining nuts from the ball joint studs, the lower control arm retaining nut, the Steering Knuckle assembly from the vehicle, and set on a bench, the ball joint using the J 6627-A and the wheel hub and bearing assembly.