Q: What should be noticed when servicing the Hazard And Turn Signal Flasher?
A:
The hazard and turn signal flashers have been integrated with the hazard switch.
By Bob
GM Specialist
01/11/2022
FAQ for Other Repair Info
Q: What is the removal procedure for the Body Control Module?
A:
Ensure that the ignition switch is in the off position, remove the right sound insulator, remove the Body Control Module, and disconnect the BCM connectors from the BCM.
Q: What is the installation procedure for the Hazard Warning Switch?
A:
Align the hazard warning switch to the opening in the I/P cluster trim plate. Push inward on the hazard warning switch until fully seated into the I/P cluster trim plate. Connect the electrical connector to the hazard warning switch. Connect the dimmer switch electrical connector if required. Install the I/P cluster trim plate to the I/P carrier. Enable the SIR.
Q: What is the removal procedure for the Stop Lamp Switch?
A:
Remove the left Instrument Panel closeout/insulator panel. Disconnect the electrical connections. Rotate the stop lamp switch counterclockwise until the travel stop has been reached. Pull the stop lamp switch rearward. Remove the stop lamp switch.