Remove the door lock cylinder by removing the retaining clip.
By Bob
GM Specialist
01/11/2022
Q: What should be done before servicing the Outside Handle and Lock Cylinder?
A:
Raise the window to the full-up position.
By Bob
GM Specialist
01/11/2022
FAQ for Other Repair Info
Q: What is the installation procedure for the Lock Actuator?
A:
Position the front Door Lock Actuator to the front door lock, install the front door lock actuator screws, and install the front door locking module.
Q: What is the removal procedure for the Power Door Lock Switch?
A:
Remove the door handle bezel. Release the retaining tabs for the power Door Lock Switch from the door handle bezel. Disconnect the electrical connector from the power door lock switch.
Q: What is the recommended torque for the rear door check link nuts?