2005 Buick Rainier Power Seat Switch

You should lift up on the front edge of the door lock and side window switch to release the front retaining clip, lift up on the rear edge of the switch panel to release the 2 rear retaining clips, and remove the electrical connector from the memory seat switch and the memory seat switch from the lock and door lock and side window switch.

You should remove the seat from the vehicle, the two bolts securing the rear seat cushion assembly to the seat latch rod, the seat riser latch assembly from the seat latch rod, the retainer nut from each end of the seat latch rod, and the seat latch rod.

You should remove the seat from the vehicle, unclip the front, rear, and side J-strips on the underside of the seat, remove the lumbar knob by pulling the knob straight away from the seat, the recliner handle, the screws that retain the lumbar adjustment mechanism to the seat adjuster, the lumbar cable, the 2 bolts securing the seat recliner to the seat adjuster and the seat back assembly from the seat cushion assembly, disconnect the seat belt buckle electrical connector and the wiring harness from the seat position switch, remove the bolt securing the seat belt buckle assembly to the seat adjuster, the seat cushion cover and foam, the assist spring, the 4 nuts securing the seat cushion frame to the seat adjusters, the seat adjusters and the 2 nuts securing the seat position switch to the seat adjuster and drill out the rivets securing the sensor to the bracket.

You should connect the electrical connector to the switch, install the seat switch to the seat bezel assembly, verify that the retaining tabs are fully seated, and install the buttons on the switch and the switch bezel assembly to the seat assembly.

You should remove the 3 screws that retain the switch bezel to the seat, remove the switch bezel from the seat, the seat switches from the switch bezel by releasing the retaining tabs, the lumbar switch from the switch bezel, and the switch bezel from the seat.