2005 Buick Park Avenue | Base, Ultra | 6 Cyl 3.8 L GAS
FAQ for Window Channel Repair
Q: How to install the Window Channel-Rear Door Front?
A:
First, you need to install the front window run channel. Then, please tighten the 2 front window run channel bolts. Finally, you should install the water deflector and the trim panel.
By Bob
GM Specialist
02/11/2022
Q: How to remove the Window Channel-Rear Door Front?
A:
First, you need to close the window, remove the trim panel, and remove the water deflector. Then, please loosen the 2 front window run channel bolts, and lift the channel so that the fasteners will clear the keyhole slots in the door panel. Finally, you should remove the front window run channel through the opening in front of the window module.
By Bob
GM Specialist
02/11/2022
Q: What is the recommended torque for the front window run channel bolts?
A:
The recommended torque is 9 N.m (80 lb in).
By Bob
GM Specialist
02/11/2022
FAQ for Other Repair Info
Q: How to remove the Motor-Power Window?
A:
First, you need to remove the door trim panel and the water deflector. Then, please disconnect the electrical connector and remove the power Window Motor.
Q: How to remove the Power Window Switch-Rear Door?
A:
First, you need to open the ashtray lid, insert your fingers into the front portion of the opening, and lift the front portion up to release the spring clip. Then, please slide the switch plate forward to release the rear retainer tabs, and disconnect the electrical connectors. Finally, you should release the retainer tabs on the switch plate, and remove the power Window Switch.
Q: What is the recommended torque for the upper fasteners?