2005 Buick Park Avenue Window Motor

First, you need to install the motor and the fasteners. Then, please connect the electrical connectors. Finally, you should install the water deflector and the door trim panel.

The recommended torque is 10 N.m (89 lb in).

First, you need to remove the door trim panel and the water deflector. Then, please disconnect the electrical connector and remove the power window motor.

First, you need to remove the door trim panel, the water deflector, and the trim panel bracket, disconnect the outside door handle rod from the door latch, and reconnect the power window switch. Then, please lower the window, release the window from the module, manually lift the window to the fully closed position, tape the window in place, disconnect the power window motor electrical connector and the door latch wiring harness, remove the power window module with the door latch attached. Finally, you should disconnect the inside door handle and lock rods, and remove the door latch wiring harness, and the door latch from the power, the inside door handle, and lock rods.

First, you need to remove the door trim panel, the door control module, the water deflector, the speaker assembly, and the window. Then, please disconnect the lock rod from the outside door handle, disconnect the outside handle rod, remove the 3 fasteners from the door latch assembly, and remove the 2 upper fasteners from the module. Finally, you should loosen the remaining fasteners, remove the module assembly, disconnect the inside door handle and lock rods, and lift the door latch off the retainer.