2005 Buick Park Avenue Brake Hose

The recommended torque is 9 N.m (80 lb in).

First, you need to remove the tire and wheel assembly, clean all dirt and foreign material from the brake hose and the brake pipe fittings, and disconnect the brake pipe fitting from the brake hose, cap, or plug the brake pipe fitting end. Then, please remove the brake hose retainer from the brake hose, remove the brake hose from the brake hose bracket, remove the brake hose to the caliper bolt from the brake caliper, and remove the brake hose born the brake caliper. Finally, you should remove and discard the two copper brake close gaskets, install a rubber plug into the brake hose to the caliper bolt hole of the brake caliper, remove the hose bracket bolt from the strut assembly and remove the hose.

First, you need to leave approximately 19 mm (0.750 inches) of tubing extending out of the collet. Then, please insert the assembly into the J 29803-A. Finally, you should ensure that the brake pipe end contacts the face of the forming mandrel.

You need to use the J 29803-A ISO Flaring Kit.

First, you need to remove the tire and wheel assembly, clean all dirt and foreign material from the brake hose and the brake pipe fittings, and disconnect the brake pipe fitting from the brake hose and cap or plug the brake pipe fitting end. Then, please remove the brake hose retainer from the brake hose, remove the brake hose from the brake hose bracket, remove the brake hose to the caliper bolt from the brake caliper, and remove the brake hose from the brake caliper. Finally, you should remove and discard the two copper brake hose gaskets, and install a rubber plug into the brake hose to the caliper bolt hole of the brake caliper.