2005 Buick Century Wheel Bearing

You need to remove the tire and wheel, disconnect the wheel speed sensor electrical connector, remove the wheel speed sensor electrical connector from the bracket and the front wheel drive shaft nut, insert a drift or flat-bladed tool into the caliper and rotor to prevent from turning, remove the brake rotor, use 3 wheel nuts to attach the J 42129 to the wheel bearing/hub, use the J 42129 to push the wheel drive shaft out of the wheel bearing/hub and remove and discard the wheel bearing/hub bolts, the J 42129 from the hub and the wheel bearing/hub and splash shield-noting the position of the shield for reinstallation.

You need to install the wheel bearing/hub with the splash shield as noted during removal, new wheel bearing/hub bolts, the brake rotor and caliper, and the front wheel drive shaft nut, then insert a drift on a flat-bladed tool into the caliper and rotor to prevent the rotor from turning, install the wheel speed sensor electrical connector to the bracket, connect the wheel speed sensor electrical connector and install the tire and wheel.

You need to remove the tires and wheels, the brake rotor, the antilock brake system (ABS) electrical connector from the wheel speed sensor, the park brake cable from the park brake actuator, the mounting bolts from the rear bearing/hub, the wheel bearing/hub and park brake assembly from the knuckle and the park brake actuator from the rear wheel bearing/hub.

The recommended torque is 75 Nm (55 ft. lbs.).

You need to install the park brake actuator to the rear wheel bearing/hub, the wheel bearing/hub and park brake assembly to the knuckle, the wheel bearing/hub-to-knuckle bolts, the parking brake cable to the park brake actuator, the ABS electrical connector to the wheel speed sensor if equipped, the brake rotor and the tires and wheels.