2005 Buick Century Sway Bar Bushing

You need to align the flat edge of the bushing flange to the mark in the control arm, ensure that the flat edge of the bushing flange is 30 degrees from the centerline of the lower control arm and ensure that the thin slot in the bushing is facing outboard, insert the bushing into the control arm and assemble the following bushing installation tools: J 21474-27, J 21474-13, J 21474-5 and J 21474-4, and tighten J 21474-4, disassemble the bushing installation tools and install the lower control arm.

You need to remove the intermediate shaft from the steering gear stub shaft, install a utility stand to the rear of the frame, remove the rear frame bolts, lower the rear of the frame and remove the upper and lower insulators from the rear of the frame as a set.