Contact Us Live Chat or 1-888-220-8330
Search Bar
Search by Part Number or Keywords
  • My Garage
  • My Account
  • Cart
  • Body & Mirrors
  • Chassis & Brakes
  • Engine & Drivetrain
  • Electrical & Lighting
Help Center
< Back ×
  • Body & Mirrors
  • Chassis & Brakes
  • Engine & Drivetrain
  • Electrical & Lighting
Login/Register My Account Track Order Help Center Contact Us
Replacement and OEM Parts for 2005 Buick Century ABS Wheel Speed Sensor

2005 Buick Century ABS Wheel Speed Sensor

My Vehicle Change Vehicle
2005 Buick Century
Change Vehicle
Vehicle Options
We need more information about your vehicle to make a correct determination of fitment
< Back to View All
ABS & Parking Brake
  • Department
  • Brands
  • Prices

1 Product found

4 Q&A for ABS Wheel Speed Sensor Repair
Show Item:
  • 30
  • 60
  • 90
Sort by:
Recommended
Filter
Sort
View by

FAQ for ABS Wheel Speed Sensor Repair

Q: How do you remove the Wheel Speed Sensor-Rear?
A:
You need to remove the rear tire and wheel assembly, disconnect the electrical connector from the rear wheel speed sensor and remove the hub and bearing assembly.
By Bob
GM Specialist
28/10/2022
Q: How do you install the Wheel Speed Sensor-Front?
A:
You need to install the hub and bearing assembly to the vehicle, the front wheel speed sensor jumper harness electrical connector, and the wheel and tire assembly, lower the vehicle, turn the ignition switch to the ON position with the engine OFF and perform the diagnostic system check-vehicle.
By Bob
GM Specialist
28/10/2022
Q: How do you install the Wheel Speed Sensor-Rear?
A:
You need to install the hub and bearing assembly to the vehicle, connect the electrical connector to the rear wheel speed sensor, install the wheel and tire assembly, lower the vehicle, turn the ignition switch to the ON position, with the engine OFF and perform the diagnostic system check-vehicle.
By Bob
GM Specialist
28/10/2022
Q: How do you remove the Wheel Speed Sensor-Front?
A:
You need to remove the front tire and wheel assembly, disconnect the front wheel speed sensor jumper harness electrical connector and remove the hub and bearing assembly.
By Bob
GM Specialist
28/10/2022

FAQ for Other Repair Info

Q: How do you remove the Electronic Brake Control Module (EBCM)?
A:
You need to turn the ignition switch to the OFF position, remove the front fender upper diagonal brace, and disconnect the accelerator and cruise control cable from the accelerator control cable bracket and the cruise control module from the left strut tower. It is not necessary to remove the cable from the module. Then you can position the module and cables aside, remove the air cleaner intake duct, disengage the red locking tab from the connector lock tab, push down the lock tab and then move the sliding connector cover to the open position, disconnect the electronic brake control module (EBCM) harness connector, remove any dirt/debris from the assembly and the 4 EBCM to brake pressure modulator valve (BPMV) retainers and separate the EBCM from the BPMV by gently pulling apart until separated.
Q: How do you install the Park Brake Shoe?
A:
You need to assemble the park brake shoe to the actuator, install the park brake shoe and actuator onto the backing plate, position the park brake shoe, actuator, and backing plate over the rear hub, install the park brake cable bracket and the two retainers and the rear hub, and install and connect the rear park brake cable to the bracket at the rear wheel, connect the park brake cable return spring to the park brake actuator and bracket at the rear wheel, and then install the rear rotor, the rear caliper bracket, and the rear tire and wheel assemblies.