FAQ for Hvac Heater Blend Door Actuator Repair
Q: What is the first step for replacing the mode actuator (with RPO CODE D07)?
A:
The first step is to remove the floor air outlet duct extension from the floor duct.
By BobGM Specialist
01/11/2022 Q: What is the removal procedure for the right air temperature actuator?
A:
The procedure is to remove the following: the I/P carrier, the screws from the right air temperature actuator, and the right air temperature actuator from the HVAC module assembly.
By BobGM Specialist
01/11/2022 Q: What is the recommended torque when installing the recirculation actuator retaining screws?
A:
You can tighten the screws to 1.6 N.m (14 lb in).
By BobGM Specialist
01/11/2022 Q: What is the removal procedure for the recirculation actuator (Visteon)?
A:
The procedure is to remove the following: the screws from the evaporator core cover, the evaporator core cover from the HVAC module assembly, the screws from the recirculation actuator, and the recirculation actuator from the HVAC module assembly.
By BobGM Specialist
01/11/2022 Q: What is the recommended torque when installing the screws to the left air temperature actuator?
A:
You can tighten the screws to 2 N.m (18 lb-ft).
By BobGM Specialist
01/11/2022 Q: What is the recommended torque when installing the mode actuator mounting screws to the HVAC module?
A:
You can tighten the screws to 1.6 N.m (14 lb in).
By BobGM Specialist
01/11/2022 Q: What is the removal procedure for the recirculation actuator?
A:
The procedure is to remove the air distribution duct, disconnect the electrical connection, remove the recirculation actuator retaining screws, and remove the recirculation actuator.
By BobGM Specialist
01/11/2022 Q: What is the removal procedure for the left air temperature actuator?
A:
The procedure is to remove the following: the I/P insulator panel, the screws from the left air temperature actuator, and the left air temperature actuator.
By BobGM Specialist
01/11/2022 Q: What is the removal procedure for the auxiliary air temperature actuator?
A:
The procedure is to remove the following: the right rear quarter trim panel, the retaining screws from the auxiliary air temperature actuator, and the auxiliary air temperature actuator from the rear auxiliary HVAC module.
By BobGM Specialist
01/11/2022 Q: What is the recommended torque when installing the screws to the right air temperature actuator?
A:
You can tighten the screws to 2 N.m (18 lb in).
By BobGM Specialist
01/11/2022 See more FAQs (12)