Part Description: 2004 Chevrolet Silverado 1500 Sensor Asm, Manual Transmission Output Speed
More Info
Vehicle Fitment
2004 Chevrolet Silverado 1500 | Base, Hybrid, LS, LT, SS, WT, Z71 | 6 Cyl 4.3 L GAS, 8 Cyl 4.8 L GAS, 8 Cyl 5.3 L ELECTRIC/GAS, 8 Cyl 5.3 L FLEX, 8 Cyl 5.3 L GAS, 8 Cyl 6.0 L GAS
FAQ for Vehicle Speed Sensors Repair
Q: What is the proper way to install the vehicle speed sensor (VSS)?
A:
The proper way is to lubricate a NEW O-ring seal with transmission fluid, install the VSS and bolt, lower the vehicle, and then check the transmission fluid level.
By Bob
GM Specialist
01/11/2022
Q: What is the removal procedure for the output shaft speed sensor?
A:
The procedure is to raise and suitably support the vehicle, disconnect the output speed sensor electrical connector, remove the output speed sensor, and then inspect the output speed sensor.
By Bob
GM Specialist
01/11/2022
Q: What is the removal procedure for the vehicle speed sensor (VSS)?
A:
The procedure is to raise and suitably support the vehicle, and then remove the VSS bolt, sensor and seal.
By Bob
GM Specialist
01/11/2022
Q: What is the removal procedure for the input shaft speed sensor?
A:
The procedure is to raise and suitably support the vehicle, disconnect the input speed sensor electrical connector, remove the input speed sensor, and then inspect the input speed sensor.
By Bob
GM Specialist
01/11/2022
Q: What is the proper way to install the input shaft speed sensor?
A:
The proper way is to install the input speed sensor, connect the input speed sensor electrical connector, and then lower the vehicle.
By Bob
GM Specialist
01/11/2022
Q: What is the proper way to install the output shaft speed sensor?
A:
The proper way is to install the output speed sensor, connect the output speed sensor electrical connector, and then lower the vehicle.
By Bob
GM Specialist
01/11/2022
See more FAQs (1)
FAQ for Other Repair Info
Q: What is the removal procedure for the transmission mount?
A:
The procedure is to raise and support the vehicle, support the transmission, raise the transmission, and then remove the Transmission Mount.
Q: What is the proper way to install the automatic transmission fluid/filter?
A:
The proper way is to install the new filter seal, the new filter, the oil pan, the new gasket, the oil pan bolts, and the oil pan drain plug.
Q: What is the proper way to install the control and shift solenoids?
A:
The proper way is to install the 3-2 control solenoid, the 2-3 shift solenoid, the 1-2 shift solenoid, the pressure control solenoid, the pressure control solenoid retainer, and the transmission filter.