Part Description: 2004 Chevrolet Silverado 1500 Panel Asm-Front Side Door Upper Front Trim *Neutral
More Info
Vehicle Fitment
2004 Chevrolet Silverado 1500 | Base, Hybrid, LS, LT, LTZ, SS, WT, Z71 | 6 Cyl 4.3 L GAS, 8 Cyl 4.8 L GAS, 8 Cyl 5.3 L ELECTRIC/GAS, 8 Cyl 5.3 L FLEX, 8 Cyl 5.3 L GAS, 8 Cyl 6.0 L GAS
FAQ for Door Armrest Repair
Q: What is the procedure for correction?
A:
The procedure is to open the armrest lid, remove the armrest inner panel, fold the seat backs to gain access to the hinge pin, install the two springs and the inner lid, and then place the seat back in the upright position.
By Bob
GM Specialist
02/11/2022
Q: What should be done after replacing the passenger door module (PDM)?
A:
You should perform the service Programming System (SPS), the transmitter Programming, and the control Module Setup.
By Bob
GM Specialist
01/11/2022
Q: What is the removal procedure for the armrest?
A:
The procedure is to remove the door trim panel, the armrest retaining screws, and the armrest.
By Bob
GM Specialist
29/10/2022
Q: What is the proper way to install the armrest?
A:
The proper way is to install the armrest, the armrest retaining screws, and the door trim panel.
By Bob
GM Specialist
29/10/2022
FAQ for Other Repair Info
Q: What is the proper way to install the seat cushion trim cover and pad?
A:
The proper way is to install the seat cushion heater element, the inflatable restraint passenger presence system, the Seat Cushion Pad, the lumbar actuator, the seat switch bezel, the pressure sensor, and the front seat trim panel.
Q: What is the proper way to install the cupholder (Non-Luxury)?
A:
The proper way is to install the Cup Holder by pushing inwards, and then ensure around the corners of the cup holder are seated properly.
Q: What is the removal procedure for the hinge pillar trim panel?
A:
The procedure is to remove the door-sill plate and the hinge pillar panel.